Toyota Tacoma (2005–2015) Owners Manual: Outside rear view mirrors
Mirror angle can be adjusted.
Power-adjustable type
Select a mirror to adjust.
(L: left or R: right)
Adjust the mirror up, down, in or
out using the switch.
Manually adjustable type
Adjust the mirror up, down, in or out by pushing the mirror surface.
Folding back the mirrors
Push backward to fold the mirrors.
■Mirror operating conditions (vehicles with power-adjustable type only)
The engine switch is in the ACC or ON position.
CAUTION
■When driving the vehicle
Observe the following precautions while driving.
Failing to do so may result in loss of control of the vehicle and cause an accident, resulting in death or serious injury.
●Do not adjust the mirrors while driving.
●Do not drive with the mirrors folded back.
●Both the driver and passenger side mirrors must be extended and properly adjusted before driving.
NOTICE
■If ice should jam the mirror
Do not operate the control or scrape the mirror face. Use a spray de-icer to free the mirror.
Anti-glare inside rear view mirror
Glare from the headlights of vehicles behind can be reduced by using the following
functions.
Manual anti-glare inside rear view
mirror
Normal position
Anti-glare position
Auto anti-glare ...
Other materials:
ECU Power Source Circuit
DESCRIPTION
This circuit supplies power to the millimeter wave radar sensor assembly when
the ignition switch is ON.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCEDURE
...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FRONT WIPER MOTOR (for Driver Side)
Text in Illustration
*a
Matchmark
(a) Check the stop (park) position.
(b) Operate the windshield wiper motor assembly.
(c) Stop the windshield wiper motor assembly operation.
(d) Ch ...
Ignition Hold Monitor Malfunction (B2271)
DESCRIPTION
This DTC is stored when a malfunction in the IG circuit or IG hold circuit in
the certification ECU (smart key ECU assembly) is detected.
HINT:
When the cable is disconnected and reconnected to the negative (-) battery terminal,
the power source mode returns to the state it was in ...
