DESCRIPTION
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
C1421 |
Open or Short in Master Cylinder Pressure Sensor |
Any of the following is detected:
|
Brake actuator assembly (Master cylinder pressure sensor) |
C1423 |
Master Cylinder Pressure Sensor Zero Point Low Malfunction |
Master cylinder pressure is below -0.744 MPa (-7.6 kgf/cm2, -107 psi) for 5 seconds or more. |
Brake actuator assembly (Master cylinder pressure sensor) |
C1424 |
Master Cylinder Pressure Sensor Output Malfunction |
Any of the following is detected:
|
Brake actuator assembly (Master cylinder pressure sensor) |
C142A |
Master Cylinder Pressure Sensor Internal Malfunction |
Any of the following is detected:
|
Brake actuator assembly (Master cylinder pressure sensor) |
C1449 |
Master Cylinder Output Value Malfunction |
Master cylinder pressure sensor invalid condition continues for 0.2 seconds or more. |
Brake actuator assembly (Master cylinder pressure sensor) |
HINT:
DTC will be output when conditions for any of the patterns in the table above are met.
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (See page ).
PROCEDURE
1. |
REPLACE BRAKE ACTUATOR ASSEMBLY |
(a) Replace the brake actuator assembly (master cylinder pressure sensor) (See page ).
NEXT |
END |
ECU Malfunction (B1003)
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
B1003
A malfunction in the non-volatile storage of the central gateway ECU
(network gateway ECU) is detected.
Central gateway ECU (network gateway ECU)
PROC ...
Door Control Transmitter(w/ Smart Key System)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE TRANSMITTER BATTERY
Inspection
INSPECTION
PROCEDURE
1. INSPECT ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY
(a) Inspect the operation of the electrical key transmitter sub-assembly.
(1) Remove the transmitter ba ...
Transmission Fluid Temperature Sensor "B" Circuit Low Input (P2742,P2743)
DESCRIPTION
The No. 2 ATF temperature sensor is installed in the transmission valve body
assembly.
If the ECM detects an abnormally high ATF temperature near this sensor, it illuminates
the warning indicator.
HINT:
The temperature of ATF easily rises when towing, climbing hills, in
...