ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (See page ). |
|
(b) With the lower No. 1 instrument panel airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 1 instrument panel airbag assembly with a new one:
Cuts, minute cracks or marked discoloration on the lower No. 1 instrument panel airbag assembly.
2. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag has not Deployed)
(a) Perform a diagnostic system check (See page ). |
|
(b) With the lower No. 1 instrument panel airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 1 instrument panel airbag assembly with a new one:
CAUTION:
For removal and installation procedures of the lower No. 1 instrument panel airbag assembly, be sure to follow the correct procedure.
Lost Communication With ECM/PCM "A" Missing Message (U010087)
DESCRIPTION
The engine control unit and transmission control unit are located inside the
ECM. The engine control unit intercommunicates with the transmission control ECU
via CAN communication. If there is a problem in this intercommunication, the ECM
stores this DTC.
DTC Code
...
Rear Body Side Panel Protector
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR BODY SIDE PANEL PROTECTOR
(a) for Sho ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK/CLEAR (When Using Techstream)
(a) Check the DTC.
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Read the DTCs following the prompts on the Techstream screen. Enter the ...