Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR BODY SIDE PANEL PROTECTOR
(a) for Short Deck:
(1) Engage the 2 guides and 14 claws to install the rear body side protector.
(b) for Long Deck:
(1) Engage the 2 guides and 19 claws to install the rear body side protector.
(c) Remove the protective tape.
2. INSTALL TOP COVER SUB-ASSEMBLY (w/ Tonneau Cover)
(See page )
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE TOP COVER SUB-ASSEMBLY (w/ Tonneau Cover)
(See page )
2. REMOVE REAR BODY SIDE PANEL PROTECTOR
(a) Put protective tape around the rear body side panel protector.
Text in Illustration
*A |
for Short Deck |
*B |
for Long Deck |
*a |
Protective Tape |
- |
- |
(b) for Short Deck:
(1) Disengage the 15 claws and 2 guides to remove the rear body side panel protector.
(c) for Long Deck:
(1) Disengage the 19 claws and 2 guides to remove the rear body side panel protector.
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
(a) Disconnect the A36 air conditioning amplifier assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side with the connector disco ...
Cargo and luggage
Take notice of the following information about storage precautions, cargo
capacity and load.
● Stow cargo and luggage in the rear deck whenever possible.
● Be sure all items are secured in place.
● Be careful to keep the vehicle level. Placing the weight as far forward as
po ...
Automatic Disconnecting Differential Motor Limit Switch Circuit (P17A4)
DESCRIPTION
When the A.D.D. actuator switches between 2WD and 4WD, the DL1 and DL2 terminals
of the limit switch and ADD terminal of the A.D.D. position switch change to one
of the following ON/OFF combinations listed in the table below.
Terminal
In 2WD
Switchi ...