Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Lost Communication With ECM/PCM "A" Missing Message (U010087)

Toyota Tacoma (2015-2018) Service Manual / Rc62f Manual Transmission / Transaxle / Manual Transmission System / Lost Communication With ECM/PCM "A" Missing Message (U010087)

DESCRIPTION

The engine control unit and transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control ECU via CAN communication. If there is a problem in this intercommunication, the ECM stores this DTC.

DTC Code

DTC Detection Condition

Trouble Area

SAE

U010087

Following conditions are met for 1.25 seconds (1 trip detection logic):

  1. The ignition switch is ON
  2. Battery voltage is 9.5 V or more
  3. No communication between engine control unit and transmission control unit

ECM

U0100

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

  1. Check that the battery voltage is 9.5 V or more.
  2. Turn the ignition switch to ON.
  3. Check for DTCs again (See page ).

PROCEDURE

1.

CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U010087)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Enter the following menus: Powertrain / Transmission / Trouble Codes.

(d) Check if DTCs are output.

Result

Result

Proceed to

Only DTC U010087 is output

A

DTC U010087 and other DTCs are output

B

A

REPLACE ECM

B

GO TO DTC CHART

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Manual Transmission System DTC Code Detection Item MIL Memory See page P03352A Cranks ...

Crankshaft Position Sensor "A" Signal Stuck in Range (P03352A,P033531)
DESCRIPTION The crankshaft position sensor system consists of a crankshaft position sensor plate and a pickup coil. The crankshaft position sensor plate has 34 teeth and is installed to the crank ...

Other materials:

Immobiliser System does not Operate Properly
DESCRIPTION The engine immobiliser system compares the ID code that is registered in the certification ECU (smart key ECU assembly) with the ID code of the transponder chip that is embedded in the electrical key transmitter sub-assembly. WIRING DIAGRAM (See page ). CAUTION / NOTICE / HINT ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or sig ...

Rear Power Outlet Switch
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT MAIN SWITCH ASSEMBLY (a) Check the main switch assembly. (1) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Com ...

В© 2011-2024 Copyright www.ttguide.net