DESCRIPTION
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
C1428 |
Motor Circuit Malfunction |
With the motor relay and motor fail-safe relay OFF, open or short in motor circuit continues for 2 seconds or more. |
Brake actuator assembly (Motor circuit) |
WIRING DIAGRAM
Refer to DTCs C142B, C146C and C146D (See page ).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (See page ).
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
(a) Turn the ignition switch off.
(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(c) Disconnect the S1 skid control ECU (brake actuator assembly) connector.
(d) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE BRAKE ACTUATOR ASSEMBLY |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT) |
Steering Angle Sensor Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Steering Angle Sensor Communication Stop Mode
Either condition is met:
Communication stop for "Spiral cable (Steering Angle Sensor)"
is indicated on the "C ...
Main Switch Illumination Circuit
DESCRIPTION
When the light control switch is turned to the tail or head position, this circuit
sends an illumination signal to the wireless charger main switch (mobile wireless
charger switch). Based on this signal, the wireless charger main switch (mobile
wireless charger switch) is illumina ...
Cruise control
Use the cruise control to maintain a set speed without depressing the accelerator
pedal.
Indicator
Cruise control switch
■ Setting the vehicle speed
Press the ON-OFF button to activate the cruise control.
Cruise control indicator will come on.
Press the button again to deactivate ...