DESCRIPTION
When the light control switch is turned to the tail or head position, this circuit sends an illumination signal to the wireless charger main switch (mobile wireless charger switch). Based on this signal, the wireless charger main switch (mobile wireless charger switch) is illuminated.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL) |
(a) Disconnect the M7 wireless charger main switch (mobile wireless charger switch) connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
M7-10 (ILL+) - Body ground |
Light control switch in tail or head position |
11 to 14 V |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
2. |
CHECK HARNESS AND CONNECTOR (WIRELESS CHARGER MAIN SWITCH - BODY GROUND) |
(a) Disconnect the M7 wireless charger main switch (mobile wireless charger switch) connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
M7-9 (ILL-) - Body ground |
Always |
Below 1 Ω |
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR ENGINE OIL SEAL
(a) Apply MP grease to the lip of a new rear engine oil seal.
NOTICE:
Keep the lip free of foreign matter.
(b) Using SST, tap in a new rear engine oil seal until its surface is
flush with the rear engine oil seal retainer ed ...
Components
COMPONENTS
ILLUSTRATION
*A
w/ Front Spoiler
-
-
*1
RADIATOR GRILLE
*2
FRONT NO. 1 WHEEL OPENING EXTENSION PAD
ILLUSTRATION
*A
w/o Over Fender
-
- ...
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the battery terminal. Therefore, make sure to read the disconnecting
the cable from the battery terminal notice before proceeding with work.
Click ...