DESCRIPTION
These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B1551 |
When one of the conditions below is met:
|
Radio and display receiver assembly |
B158D |
The internal video signal of the radio and display receiver assembly is interrupted. |
|
B15A0 |
When either condition below is met:
|
|
B15B0 |
Picture circuit (TFT unit) malfunction |
|
B15B3 |
When one of the conditions below is met:
|
|
B15B4 |
When one of the conditions below is met:
|
|
B15B7 |
"Bluetooth" module malfunction |
PROCEDURE
1. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
OK |
USE SIMULATION METHOD TO CHECK |
NG |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE STEERING GEAR OUTLET RETURN TUBE
(a) Using a union nut wrench, remove the steering gear outlet return tube.
2. REMOVE STEERING TURN PRESSURE TUBE
(a) Using a union nut wrench, remove the 2 pressure tubes.
(b) Remove the 4 O-rings from the pressure tubes.
3. ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE INTAKE VALVE
(a) Using SST, compress the inner compression spring and remove the valve
spring retainer locks.
SST: 09202-70020
SST: 09202-00021
09202-01010
09202-01020
(b) Remove the valve s ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSPECT CENTER NO. 2 SUPPORT BEARING ASSEMBLY
(a) Turn the center bearing by hand, check that it turns smoothly without catching
and that there are no cracks or damage.
If there are any defects, replace it.
2. INSTALL CENTER NO. 2 SUPPORT BEARING ASSEMBLY
(a) Instal ...