DISASSEMBLY
PROCEDURE
1. REMOVE INTAKE VALVE
(a) Using SST, compress the inner compression spring and remove the valve spring retainer locks. SST: 09202-70020 SST: 09202-00021 09202-01010 09202-01020 |
|
(b) Remove the valve spring retainer, inner compression spring and intake valve.
HINT:
Arrange the removed parts in the correct order.
2. REMOVE EXHAUST VALVE
(a) Using SST, compress the inner compression spring and remove the valve spring retainer locks. SST: 09202-70020 09202-01010 09202-01020 SST: 09202-00021 |
|
(b) Remove the valve spring retainer, inner compression spring and exhaust valve.
HINT:
Arrange the removed parts in the correct order.
3. REMOVE VALVE STEM OIL SEAL
(a) Using needle-nose pliers, remove the valve stem oil seals. |
|
4. REMOVE VALVE SPRING SEAT
(a) Using compressed air and a magnet hand, remove the valve spring seats by blowing air onto them. |
|
5. REMOVE NO. 1 STRAIGHT SCREW PLUG
NOTICE:
If water leaks from a straight screw plug or the plug is corroded, replace it.
(a) Using a 10 mm hexagon wrench, remove the 4 No. 1 straight screw plugs and 4 gaskets. Text in Illustration
|
|
6. REMOVE NO. 2 STRAIGHT SCREW PLUG
NOTICE:
If water leaks from a straight screw plug or the plug is corroded, replace it.
(a) Using a 14 mm hexagon wrench, remove the 2 No. 2 straight screw plugs and 2 gaskets. Text in Illustration
|
|
7. REMOVE NO. 3 STRAIGHT SCREW PLUG
NOTICE:
If water leaks from a straight screw plug or the plug is corroded, replace it.
(a) Using a 10 mm hexagon wrench, remove the 8 No. 3 straight screw plugs and 8 gaskets. Text in Illustration
|
|
8. REMOVE UNION
NOTICE:
It is not necessary to remove the union unless it is being replaced.
9. REMOVE STUD BOLT
NOTICE:
If the stud bolt is deformed or the threads are damaged, replace it.
Center Airbag Sensor Assembly Malfunction (B1000/31)
DESCRIPTION
The airbag sensor assembly consists of a deceleration sensor, safing sensor,
drive circuit, diagnosis circuit, ignition control, etc.
If the airbag sensor assembly receives signals from the deceleration sensor,
it determines whether or not the SRS should be activated.
DTC B1000/31 ...
Power Window Switch Malfunction (B2312)
DESCRIPTION
The power window regulator motor assembly is operated by the power window regulator
master switch assembly or power window regulator switch assembly. The power window
regulator motor assembly has motor, regulator and ECU functions.
This DTC is output when the ECU built into the reg ...
Reservoir Level Switch Disconnected (C1453,C1454)
DESCRIPTION
The brake fluid level warning switch sends the appropriate signal to the skid
control ECU (master cylinder solenoid) when the brake fluid level drops.
DTC Code
DTC Detection Condition
Trouble Area
C1453
With the ECU termina ...