DESCRIPTION
The power window regulator motor assembly is operated by the power window regulator master switch assembly or power window regulator switch assembly. The power window regulator motor assembly has motor, regulator and ECU functions.
When the ECU determines that the power window regulator motor assembly has not been initialized, DTC B2313 is set.
HINT:
DTC B2313 can be stored in each power window regulator motor assembly (power window ECU).
D-Door Motor (Front Power Window Regulator Motor Assembly LH)
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B2313 |
|
|
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B2313 |
|
|
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
PERFORM INITIALIZATION (APPLICABLE LOCATION) |
(a) Turn the ignition switch to ON.
(b) Initialize the power window regulator motor assembly (See page ).
HINT:
Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.
|
2. |
CHECK DTC OUTPUT |
(a) Turn the ignition switch off.
(b) Wait for at least 10 seconds, and then turn the ignition switch to ON.
(c) Check for DTCs (See page ).
HINT:
Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.
OK:
B2313 output does not recur.
Result
Result |
Proceed to |
---|---|
OK |
A |
NG (Driver side power window) |
B |
NG (Front passenger side power window) |
C |
A |
END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED) |
B |
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
C |
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH |
Terminals Of Ecu
TERMINALS OF ECU
1. ECM
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
E14-20 (TC) - E11-1 (E1)
G - W-B
DTC output signal
Ignition switch ON
...
Center Airbag Sensor Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Center Airbag Sensor Communication Stop Mode
Either condition is met:
Communication stop for "Airbag" is indicated on the "Communication
Bus Check" sc ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE FRONT BRAKE SHOE
(a) Using SST, remove the shoe return spring from the front brake shoe.
SST: 09921-00010
(b) Using needle-nose pliers, remove the return spring.
(c) Using SST, remove the shoe hol ...