DESCRIPTION
C1A10 is output when there is an internal malfunction in the millimeter wave radar sensor assembly.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
C1A10 |
Front Radar Sensor |
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the internal malfunction of the millimeter wave radar sensor assembly continues for 0.3 seconds or more. |
Millimeter wave radar sensor assembly |
CAUTION / NOTICE / HINT
NOTICE:
Click here
PROCEDURE
1. |
REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
(a) Replace the millimeter wave radar sensor assembly with a new one.
Click here
(b) Perform millimeter wave radar sensor assembly adjustment.
Click here
|
2. |
CLEAR FOR DTCs (RADAR CRUISE 2) |
(a) Clear the DTCs.
Click here
NEXT |
END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE) |
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful because intermittent conditions or signals ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Precaution
PRECAUTION
PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY
(a) When replacing the combination meter assembly, always replace it with a new
one. If a combination meter assembly which was installed to another vehicle is used,
the information stored in it will not match the information from ...