Toyota Tacoma (2015-2018) Service Manual: Engine

Toyota Tacoma (2015-2018) Service Manual / Maintenance / Engine

General Maintenance

GENERAL MAINTENANCE

CAUTION / NOTICE / HINT

HINT:

Inspect these items when the engine is cold.

PROCEDURE

1. REPLACE CHAIN SUB-ASSEMBLY

HINT:

2TR-FE: See page
2GR-FKS: See page

2. INSPECT DRIVE BELT

HINT:

2TR-FE: See page
2GR-FKS: See page

3. REPLACE SPARK PLUGS

HINT:

2TR-FE: See page
2GR-FKS: See page

4. REPLACE AIR CLEANER FILTER

(a) Replace the air filter with a new one.

5. REPLACE ENGINE OIL AND OIL FILTER

HINT:

2TR-FE: See page
2GR-FKS: See page

6. REPLACE ENGINE COOLANT

HINT:

2TR-FE: See page
2GR-FKS: See page

7. INSPECT RADIATOR FIN

(a) Check that the radiator and condenser are not blocked with leaves, dirt, or insets, and clean the hose connection.

8. INSPECT GASKET IN FUEL TANK CAP

HINT:

2TR-FE: See page
2GR-FKS: See page

9. INSPECT CHARCOAL CANISTER

HINT:

2TR-FE: See page
2GR-FKS: See page

10. INSPECT FUEL LINES, CONNECTIONS AND FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BAND

(a) Visually check the fuel lines for cracks, leakage, loose connections, deformation or tank band looseness.

11. INSPECT EXHAUST PIPE AND MOUNTING

(a) Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.

Chassis

General Maintenance GENERAL MAINTENANCE PROCEDURE 1. INSPECT STEERING LINKAGE (a) Check the steering wheel free play (See page ). (b) Check the steering linkage for looseness or damage. (1) ...

Inside Vehicle

General Maintenance GENERAL MAINTENANCE CAUTION / NOTICE / HINT Performing these maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or ta ...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT TIRES (a) Check the tires for wear and proper inflation pressure. Standard Cold Tire Inflation Pressure: Tire Size Front Wheel kPa (kgf/cm2, psi) Rear Wheel kPa (kgf/cm2, psi) Spare Wheel kPa (kgf/cm2, psi) ...

Installation
INSTALLATION PROCEDURE 1. INSTALL TRANSMISSION WIRE (a) Coat 2 new O-rings with ATF, and install them to the 2 temperature sensors. (b) Coat a new O-ring with ATF, and install it to the transmission wire. (c) Install the transmission wire to the automatic transmission case sub-assembly with t ...

Turn signal lever
Right turn Left turn Move and hold the lever partway to signal a lane change. The right hand signal will flash until you release the lever. Move and hold the lever partway to signal a lane change. The left hand signal will flash until you release the lever. ■Turn signals can be ...