General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. INSPECT STEERING LINKAGE
(a) Check the steering wheel free play (See page ).
(b) Check the steering linkage for looseness or damage.
(1) Check that the tie rod ends do not have excessive play.
(2) Check that the dust seals and boots are not damaged.
(3) Check that the boot clamps are not loose.
2. INSPECT STEERING GEAR HOUSING OIL
(a) Check the steering gear housing for oil leakage.
HINT:
If leakage is found, check and repair the cause.
3. INSPECT BALL JOINTS AND DUST COVERS
(a) Inspect the ball joints for excessive looseness.
(b) Check the dust cover for damage.
4. INSPECT DRIVE SHAFT BOOT (for 4WD)
(a) Check the drive shaft boots for clamp looseness, oil leakage or damage.
5. REPLACE TRANSFER OIL (for 4WD)
(a) Remove the filler plug and feel inside the hole with your finger.
(b) Check that the oil comes to within 5 mm (0.20 in.) from the bottom edge of the hole.
HINT:
If the level is low, add oil until it begins to run out of the filler hole.
6. REPLACE DIFFERENTIAL OIL
(a) Remove the filler plug and feel inside the hole with your finger.
(b) Check that the oil comes to within 5 mm (0.20 in.) from the bottom edge of the hole.
HINT:
If the level is low, add oil until it begins to run out of the filler hole.
7. ADJUST AUTOMATIC TRANSMISSION FLUID
HINT:
8. INSPECT MANUAL TRANSMISSION OIL
HINT:
RC62F (See page )
9. LUBRICATE PROPELLER SHAFT (for 4WD)
(a) Lubricate propeller shaft, referring to the lubrication chart. Before pumping in grease, wipe off any mud and dust on the grease fitting (See page or ).
Grease grade:
Lithium base chassis grease NLGI No. 2
10. TIGHTEN PROPELLER SHAFT BOLT
(a) Tighten the bolts for propeller shaft.
HINT:
11. ROTATE TIRES
Symbols used in illustrations
The symbol of a circle with a slash
through it means “Do not”, “Do not do this”, or “Do not let this happen”.
Arrows indicating operations
Indicates the action (pushing, turning,
etc.) used to operate switches and other devices.
Indicates the outcome of an operation
(e.g. a ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Perform the following procedure to troubleshoot the dynamic radar cruise
control system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
Pressure Control Solenoid "B" Circuit Open (P077513)
DESCRIPTION
Changing from 1st to 6th is performed by the ECM turning shift solenoid valves
SL1, SL2, SL3 and SL4 on and off. If an open or short circuit occurs in any of the
shift solenoid valves, the ECM controls the remaining normal shift solenoid valves
to allow the vehicle to be operated ...