DIAGNOSTIC TROUBLE CODE CHART
TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM
DTC Code |
Detection Item |
See page |
---|---|---|
P163B |
4WD ECU Malfunction |
|
P17A0 |
Automatic Disconnecting Differential Motor Control Circuit Open |
|
P17A4 |
Automatic Disconnecting Differential Motor Limit Switch Circuit |
|
P17A8 |
Transfer Shift Motor Control Circuit Circuit Open |
|
P17A9 |
Transfer Shift Motor Control Circuit Low |
|
P17AA |
Transfer Shift Motor Control Circuit High |
|
P17AC |
Transfer Shift Motor Limit Switch Circuit |
|
P17C7 |
Front Differential Oil Temperature Sensor Circuit Low |
|
P17C8 |
Front Differential Oil Temperature Sensor Circuit High |
|
P2772 |
Four Wheel Drive (4WD) Low Switch Circuit Range / Performance |
|
P279E |
Four Wheel Drive (4WD) Range Signal Circuit Range / Performance |
|
U0100 |
Lost Communication with ECM / PCM "A" |
|
U0122 |
Lost Communication with Vehicle Dynamics Control Module |
|
U0416 |
Invalid Data Received From Vehicle Dynamics Control Module |
|
ECM Communication Circuit Malfunction (C1203)
DESCRIPTION
The circuit is used to send TRAC and VSC control information from the skid control
ECU (brake actuator assembly) to the ECM, and engine control information from the
ECM to the skid control ECU (brake actuator assembly) through the CAN communication
system.
for 4WD or w/ Rear Diff ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FUEL PUMP
(a) Inspect the resistance of the fuel pump.
(1) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Component without harness connected
(Fuel Pump)
...
Reassembly
REASSEMBLY
PROCEDURE
1. INSPECT CENTER NO. 2 SUPPORT BEARING ASSEMBLY
(a) Turn the center bearing by hand, check that it turns smoothly without catching
and that there are no cracks or damage.
If there are any defects, replace it.
2. INSTALL CENTER NO. 2 SUPPORT BEARING ASSEMBLY
(a) Instal ...