DESCRIPTION
This DTC is output when a short to ground in the oil temperature sensor is detected.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
P17C7 |
Front Differential Oil Temperature Sensor Circuit Low |
|
|
WIRING DIAGRAM
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND OIL TEMPERATURE SENSOR - BODY GROUND) |
(a) Disconnect the F13 4 wheel drive control ECU connector.
(b) Disconnect the F38 oil temperature sensor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
F13-5 (DT) or F38-1 (DT) - Body ground |
Always |
10 kΩ or higher |
F13-25 (DGND) or F38-2 (DGND) - Body ground |
Always |
10 kΩ or higher |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
2. |
INSPECT OIL TEMPERATURE SENSOR |
(a) Disconnect the F38 oil temperature sensor connector.
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE 4 WHEEL DRIVE CONTROL ECU |
NG |
REPLACE OIL TEMPERATURE SENSOR |
Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter
DESCRIPTION
for Navigation Function:
The navigation receiver assembly receives a vehicle speed signal from
the combination meter assembly and sends the signal to navigation receiver
assembly.
for Automatic Sound Levelizer (ASL):
This circuit is necessary for the Aut ...
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine ...
Crankshaft Position Sensor "A" Signal Stuck in Range (P03352A,P033531)
DESCRIPTION
The crankshaft position sensor system consists of a crankshaft position sensor
plate and a pickup coil. The crankshaft position sensor plate has 34 teeth and is
installed to the crankshaft. The pickup coil is made of wound copper wire, an iron
core and a magnet. The crankshaft pos ...