Toyota Tacoma (2015-2018) Service Manual: Customize Parameters

Toyota Tacoma (2015-2018) Service Manual / Cruise Control / Lane Departure Alert System / Customize Parameters

CUSTOMIZE PARAMETERS

CUSTOMIZE LANE DEPARTURE ALERT SYSTEM

NOTICE:

When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.

HINT:

The following items can be customized.

(a) Customizing with the Multi-information display

(1) Turn the ignition switch to ON.

(2) Enter the following menus: Settings Tab / Settings / Lane Departure Alert Setup

(3) Select the setting by referring to the table below.

(4) Change the settings of the lane departure alert using the steering pad switch assembly.

Lane Departure Alert

Item	Content	Setting	Default
LDA Sensitivity	Timing of lane departure warning	High (graphic display) Standard (graphic display)	Standard
Sway Warning	Vehicle sway warning function	ON/OFF	ON
Sway Warning Sensitivity	Vehicle sway detection sensitivity	High (graphic display) Normal (graphic display) Low (graphic display)	Normal

Operation Check

OPERATION CHECK CHECK LANE DEPARTURE ALERT MAIN SWITCH (a) Check the lane departure alert main switch (steering pad switch assembly) on/off operation. (1) Turn the ignition switch to ON. (2) Con ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials:

Front Crankshaft Oil Seal
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL (a) Apply MP grease to the lip of a new timing gear case or timing chain case oil seal. (b) Using SST and a hammer, tap in the timing gear case ...

Installation
INSTALLATION PROCEDURE 1. INSTALL INTAKE MANIFOLD (a) Set 2 new No. 1 intake manifold to head gaskets on cylinder head sub-assembly and cylinder head LH as shown in the illustration. NOTICE: Align the port holes of the gasket and cylinder head sub-assembly ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART VSC System DTC Code Detection Item See page C1201 Engine Control System Malfunction C1203 ECM Communication Circuit Malfunction C120B ...