Toyota Tacoma (2015-2018) Service Manual: Cursor or Map Rotates when Vehicle Stopped

Toyota Tacoma (2015-2018) Service Manual / Navigation / Multi Info Display / Navigation System / Cursor or Map Rotates when Vehicle Stopped

PROCEDURE

1.	CHECK CONDITION

(a) Check with the customer if the vehicle has been turned by a turntable.

OK:

Vehicle has not been turned by a turntable.

HINT:

If the vehicle is turned on a turntable with the ignition switch ON, the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the ignition switch off and back to ON again with the vehicle completely stopped.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

TURN IGNITION SWITCH TO ON WHEN VEHICLE IS COMPLETELY STOPPED

Vehicle Position Mark Deviates Greatly

CAUTION / NOTICE / HINT NOTICE: If standard size tires are not installed, the vehicle position mark may deviate from the route even if the navigation system is operating normally. ...

GPS Mark is not Displayed

PROCEDURE 1. CHECK CABIN (a) Check the cabin for any object that might interrupt radio reception or additional devices which use radio waves on the instrument panel ...

Other materials:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLER CONDENSER ASSEMBLY (a) If the fins of the cooler condenser assembly are dirty, clean them with water and dry them with compressed air. NOTICE: Do not damage the fins of the condenser assembly. (b) If the fins of the cooler condenser assembly ...

Steering Angle Sensor (C1A47)
DESCRIPTION The blind spot monitor sensor receives steering angle signals from the spiral cable with sensor sub-assembly via CAN communication. DTC Code DTC Detection Condition Trouble Area C1A47 A fail flag is transmitted from the ste ...

Initialization
INITIALIZATION NOTICE: Initialization can only be performed for vehicles with a tire pressure warning reset switch. If initialization is performed, the existing tire positions will be cleared, but will be automatically identified when the vehicle is driven at 37 km/h (23 mp ...