DESCRIPTION
This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.
HINT:
The certification ECU (smart key ECU assembly) controls the smart key system related items that are customizable via the audio and visual system vehicle customization screen.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B15F7 |
Certification ECU (smart key ECU assembly) vehicle setting processing malfunction |
|
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the certification ECU (smart key ECU assembly), refer to Registration (See page ).
PROCEDURE
1. |
CHECK CAN COMMUNICATION SYSTEM |
(a) Use the Techstream to check if the CAN communication system is functioning normally (See page ).
OK:
CAN communication DTCs are not output.
NG |
GO TO CAN COMMUNICATION SYSTEM |
|
2. |
CHECK SMART KEY SYSTEM (for Entry Function) |
(a) Check if the smart key system (for Entry Function) is malfunctioning (See page ).
HINT:
Customization may not be possible depending on the malfunction in the smart key system (for Entry Function).
OK:
No malfunctions are present in the smart key system (for Entry Function).
NG |
GO TO SMART KEY SYSTEM (for Entry Function) |
|
3. |
CHECK SMART KEY SYSTEM (for Start Function) |
(a) Check if the smart key system (for Start Function) is malfunctioning (See page ).
HINT:
Customization may not be possible depending on the malfunction in the smart key system (for Start Function).
OK:
No malfunctions are present in the smart key system (for Start Function).
NG |
GO TO SMART KEY SYSTEM (for Start Function) |
|
4. |
CHECK CUSTOMIZE ITEMS |
(a) Make a note of the customizable items for each certification ECU (smart key ECU assembly) related system.
HINT:
The items shown as customizable via the audio and visual system vehicle customization screen can also be changed manually. In the following step, change the items manually.
(1) Check the customize parameters list for the smart key system (for Entry Function) related items that can be customized via the audio and visual system vehicle customization screen (See page ).
(2) Check the customize parameters list for the smart key system (for Start Function) related items that can be customized via the audio and visual system vehicle customization screen (See page ).
(b) Confirm that it is possible to manually change the settings of the customize parameters for each system that are available for customization via the audio and visual system vehicle customization screen.
OK:
The items available for customization via the audio and visual system vehicle customization screen can be customized successfully using the manual procedure.
OK |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
NG |
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Installation
INSTALLATION
PROCEDURE
1. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR
(a) Check that the ignition switch is OFF.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION:
Wait at least 90 seconds after disconnecting t ...
Front Radar Sensor Beam Axis Not Adjusted (C1A14)
DESCRIPTION
After installing a new millimeter wave radar sensor assembly, if sensor beam
axis adjustment has not been performed, DTC C1A14 will be stored.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1A14
Fro ...
Headlight switch
The headlights can be operated manually.
Turning the end of the lever turns on the lights as follows:
Type A
The daytime running lights turn
on.
The side marker, parking, tail,
license plate, daytime running lights and instrument panel lights turn on.
The headlights and all lights lis ...