DESCRIPTION
These DTCs are stored when a malfunction occurs in the antenna assembly with holder which is connected to the radio and display receiver assembly.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B15FE |
The antenna assembly with holder is not connected. |
|
B15FF |
A short occurs in the antenna assembly with holder. |
CAUTION / NOTICE / HINT
NOTICE:
After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.
PROCEDURE
1. |
REPLACE ANTENNA CORD SUB-ASSEMBLY |
(a) Replace the antenna cord sub-assembly with a known good one and check if the same DTC is output again (See page ).
(1) Clear the DTCs (See page ).
(2) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
OK |
END |
|
2. |
REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
(a) Replace the No. 2 antenna cord sub-assembly with a known good one and check if the same DTC is output again (See page ).
(1) Clear the DTCs (See page ).
(2) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
OK |
END |
|
3. |
REPLACE ANTENNA ASSEMBLY WITH HOLDER |
(a) Replace the antenna assembly with holder with a known good one and check if the same DTC is output again (See page ).
(1) Clear the DTCs (See page ).
(2) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
OK |
END |
NG |
REPLACE STEREO COMPONENT TUNER ASSEMBLY |
Interior Light Circuit
DESCRIPTION
The illuminated entry system controls the interior lights.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing
the following inspection procedure.
If the main body ECU (multiplex network body ECU) i ...
Coolant
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)
2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
3. DRAIN ENGINE COOLANT
CAUTION:
Do not remove the radiator cap sub-assembly, cylinder block drain cock
plug or radiator drain ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE BRAKE ACTUATOR BRACKET NO. 1
(a) Using a hexagon wrench (5 mm), remove the screw and brake actuator bracket
No. 1.
(b) Using a screwdriver, remove the fluid level warning switch connector.
2. REMOVE BRAKE M ...