Toyota Tacoma (2015-2018) Service Manual: Center Airbag Sensor Assembly Malfunction (B1000/31)
DESCRIPTION
The airbag sensor assembly consists of a deceleration sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc.
If the airbag sensor assembly receives signals from the deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1000/31 is set when a malfunction is detected in the airbag sensor assembly.
|
DTC No. |
DTC Detecting Condition |
Trouble Area |
|---|---|---|
|
B1000/31 |
Airbag sensor assembly malfunction |
Airbag sensor assembly |
HINT:
When any other DTCs are set simultaneously with B1000/31, repair the malfunctions indicated by those DTCs first.
PROCEDURE
|
1. |
CHECK DTC |
(a) Check for DTCs (See page .gif)
).
|
Result |
Proceed to |
|---|---|
|
DTC B1000/31 is output |
A |
|
DTC B1000/31 and other DTCs are output |
B |
NOTICE:
If only DTC B1000/31 is output, do not clear the DTCs, replace the airbag sensor assembly.
HINT:
If any DTCs other than DTC B1000/31 are also output, troubleshoot those DTCs first.
| A | .gif) |
REPLACE AIRBAG SENSOR ASSEMBLY |
| B | |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
Rear Airbag Sensor LH Circuit Malfunction (B1635/24)
DESCRIPTION
The airbag sensor LH consists of parts such as the safing sensor, the diagnostic
circuit and the lateral deceleration sensor.
When the airbag sensor assembly receives signals from the ...
Front Airbag Sensor LH Circuit Malfunction (B1615/14)
DESCRIPTION
The front airbag sensor LH consists of parts such as the diagnostic circuit and
the frontal detection sensor.
When the airbag sensor assembly receives signals from the frontal decelera ...
Other materials:
Winter driving tips
Carry out the necessary preparations and inspections before driving the vehicle
in winter. Always drive the vehicle in a manner appropriate to the prevailing weather
conditions.
■ Pre-winter preparations
● Use fluids that are appropriate to the prevailing outside temperatures.
• ...
Microphone Circuit between Microphone and Radio Receiver
DESCRIPTION
The radio and display receiver assembly and telephone microphone assembly are
connected to each other using the microphone connection detection signal lines.
Using this circuit, the radio and display receiver assembly sends power to the
telephone microphone assembly, and the teleph ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR ENGINE OIL SEAL
(a) Apply MP grease to the lip of a new rear engine oil seal.
NOTICE:
Keep the lip free of foreign matter.
(b) Using SST, tap in a new rear engine oil seal until its surface is
flush with the rear engine oil seal retainer ed ...
