Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedures for the LH and RH side.
- The procedures listed below are for the LH side.
PROCEDURE
1. REMOVE VISOR ASSEMBLY
|
(a) Disengage the guide to separate the visor shaft. |
|
(b) Remove the 2 screws.
(c) Disengage the clip to separate the visor assembly.
|
(d) Disconnect the connector to remove the visor assembly. |
|
2. REMOVE VANITY LIGHT BULB
|
(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and 2 guides to remove the front lens holder LH and front lens holder RH. Text in Illustration
|
|
|
(b) Remove the 2 vanity light bulbs from the visor assembly. |
|
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedures for the LH and RH side.
- The procedures listed below are for the LH side.
PROCEDURE
1. INSTALL VANITY LIGHT BULB
(a) Install the 2 vanity light bulbs to the visor assembly.
|
(b) Engage the 2 guides and 2 claws to install the front lens holder LH and front lens holder RH. |
|
2. INSTALL VISOR ASSEMBLY
(a) Connect the connector.
(b) Engage the clip to install the visor assembly.
(c) Install the 2 screws.
(d) Engage the guide to install the visor shaft.

