Toyota Tacoma (2015-2018) Service Manual: Route cannot be Calculated

Toyota Tacoma (2015-2018) Service Manual / Navigation / Multi Info Display / Navigation System / Route cannot be Calculated

PROCEDURE

1.	SET DESTINATION

(a) Set another destination and check if the system can calculate the route correctly.

OK:

Route can be correctly calculated.

NORMAL OPERATION

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Voice Guidance does not Function

PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance settings are not off. OK: Voice guidance settings are not off. NG C ...

Voice is not Recognized

PROCEDURE 1. CHECK CONDITION (a) Check if the system voice recognition level is low when recognizing a particular voice. Result Result Proce ...

Other materials:

Steering Angle Sensor Initialization Incomplete (C1439,C1445)
DESCRIPTION The skid control ECU (brake actuator assembly) acquires steering angle sensor zero point every time the ignition switch is turned ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores the previous zero point. The steering angle ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Power Window Control System DTC Code Detection Item See page B2311 Power Window Motor Malfunction B2312 Power Window Switch Malfunction ...

Engine Switch Illumination Circuit
DESCRIPTION The illuminated entry system controls the engine switch illumination. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (POWER/ENGINE SW LIGHT) (a) Connect the Techstream to the DLC3. (b) Turn the engine switch to ON. (c) Turn the Techstream ...