TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Air Conditioning / Ptc Heater Assembly

Toyota Tacoma (2015-2018) Service Manual: Ptc Heater Assembly

Components

COMPONENTS

ILLUSTRATION

Removal

Removal

REMOVAL

PROCEDURE

1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(See page 2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY 2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY )

2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY

3. REMOVE AIR DUCT ASSEMBLY 3. REMOVE AIR DUCT ASSEMBLY

3. REMOVE AIR DUCT ASSEMBLY

4. REMOVE QUICK HEATER ASSEMBLY 4. REMOVE QUICK HEATER ASSEMBLY

4. REMOVE QUICK HEATER ASSEMBLY

(a) Disconnect the connector.

(b) Remove the 2 screws and quick heater assembly.

Inspection

INSPECTION

PROCEDURE

1. INSPECT QUICK HEATER ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a

Component without harness connected

(Quick Heater Assembly)

Standard Resistance:

Tester Connection (Terminal Code)

Switch Condition

Specified Condition

1(B) - 2(E)

Always

Below 1 Ω

3(B) - 2(E)

Always

Below 1 Ω

3(B) - 4(E)

Always

Below 1 Ω

5(B) - 4(E)

Always

Below 1 Ω

If the specified condition is not met, replace the quick heater assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL QUICK HEATER ASSEMBLY

(a) Install the quick heater assembly with the 2 screws.

(b) Connect the connector.

2. INSTALL AIR DUCT ASSEMBLY

3. INSTALL INSTRUMENT LOWER PANEL ASSEMBLY 3. INSTALL INSTRUMENT LOWER PANEL ASSEMBLY

3. INSTALL INSTRUMENT LOWER PANEL ASSEMBLY

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY 4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(See page Ptc Heater Relay Ptc Heater Relay )

    Related Tacoma materials

    How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication system. *: Use the Techstream. PROCEDURE ...

    Rear Power Outlet Socket
    Components COMPONENTS ILLUSTRATION ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL POWER OUTLET SOCKET ASSEMBLY (a) Install the clamp. (b) Connect the connector. (c) Using a torx socket wrench T30, install the 4 screws and the power outlet socket assemb ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY (a) Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual sound during operation. If there is any abnormality, replace the front shock absorber with a new one. NOTICE: When disposin ...