Toyota Tacoma (2015-2018) Service Manual: Precaution
PRECAUTION
1. PRECAUTION FOR HEADLIGHT BULB REPLACEMENT
(a) When any defects such as deformation, cracks, dents, chipping, etc. are identified on the headlight, replace it with a new one.
(b) Even if the operation seems to be normal, the fail-safe function may be defective.
(c) Since halogen bulbs (for headlight or front fog light) have pressurized gas inside and can easily be broken if scratched or dropped, special care should be taken. When handling the bulb, hold the plastic or metal part and do not touch the glass part with bare hands.
2. EXPRESSIONS OF IGNITION SWITCH
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK |
Off (Lock) |
|
Ignition Switch ACC |
ACC |
On (ACC) |
|
Ignition Switch ON |
ON |
On (IG) |
|
Engine Start |
START |
On (Start) |
Lighting System
...
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
w/ Fog Light
*B
w/ Automatic High Beam System
*C
for Manual Transmission
-
...
Other materials:
Low Output Signal of Front Speed Sensor RH (Test Mode DTC) (C1271,C1272,C1401,C1402)
DESCRIPTION
The speed sensor detects the wheel speed and sends the appropriate signals to
the skid control ECU (master cylinder solenoid). These signals are used for brake
control.
The speed sensor rotors have rows of alternating N and S magnetic poles and their
magnetic fields change when t ...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. READ DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful because intermittent conditions or sig ...
Removal
REMOVAL
PROCEDURE
1. REMOVE TIMING CHAIN COVER ASSEMBLY
(See page )
2. SEPARATE NO. 2 WATER BY-PASS PIPE (for Vacuum Brake Booster)
3. REMOVE VACUUM PUMP ASSEMBLY (for Vacuum Brake Booster)
4. SET NO. 1 CYLINDER TO TDC/COMPRESSION
5. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY
6. REMO ...
