Toyota Tacoma (2015-2018) Service Manual: Poor Sound Quality in All Modes (Low Volume)
PROCEDURE
|
1. |
CHECK AUDIO SETTINGS |
(a) Set "Treble", "Mid" and "Bass" to the initial values and check that sound is normal.
OK:
Malfunction disappears.
HINT:
Sound quality adjustment measures vary according to the type of amplifier.
| OK | .gif) |
END |
|
.gif)
|
2. |
COMPARE WITH ANOTHER VEHICLE OF SAME MODEL |
(a) Compare with another vehicle of the same model which does not have trouble to see if there is any difference in the sound quality.
OK:
No difference is found.
| OK | |
END |
| NG | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Touch Panel Switch does not Function
PROCEDURE
1.
CHECK MULTI-DISPLAY
(a) Check if there is any foreign matter caught between the display and exterior
frame of the multi-display.
OK:
No foreign matt ...
Vehicle Position Mark Deviates Greatly
CAUTION / NOTICE / HINT
NOTICE:
If standard size tires are not installed, the vehicle position mark
may deviate from the route even if the navigation system is operating normally.
...
Other materials:
Towing Tail Relay
Inspection
INSPECTION
PROCEDURE
1. INSPECT TOWING TAIL RELAY
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance between the terminals.
Standard:
Tester Connection
Specified Condition
3-5
10 kΩ or higher
...
Speed Signal Circuit
DESCRIPTION
The combination meter assembly receives the vehicle speed signal from this circuit.
The wheel speed sensors produce an output that varies according to the vehicle speed.
The wheel speed sensor output is received by the skid control ECU, which uses this
information to create the ve ...
Lost Communication with ECM / PCM "A" (U0100,U0122)
DESCRIPTION
This DTC is output when communication is lost with the skid control ECU (brake
actuator assembly) or ECM.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
U0100
Lost Communication with ECM / PCM " ...
