TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Supplemental Restraint Systems / Front Seat Side Airbag Assembly / On-vehicle Inspection

Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FRONT SEAT AIRBAG ASSEMBLY LH (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check (See page ).

(b) With the front seat airbag assembly LH installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat with a new one:

Cuts, minute cracks or marked discoloration on the front seatback around the front seat airbag assembly LH.

2. INSPECT FRONT SEAT AIRBAG ASSEMBLY LH (for Vehicle Involved in Collision and Airbag has not Deployed)

(a) Perform a diagnostic system check (See page ).

(b) With the front seat airbag assembly LH removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat airbag assembly LH with a new one:

  • Cuts, minute cracks or marked discoloration on the front seat airbag assembly LH.
  • Cracks or other damage to the wire harness or connector.

    CAUTION:

    For removal and installation procedures of the front seat airbag assembly LH, be sure to follow the correct procedure.

    Related Tacoma materials

    Dtc Check / Clear
    DTC CHECK / CLEAR 1. CHECK FOR DTC HINT: When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select th ...

    Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
    DESCRIPTION If a door glass or a power window regulator motor assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window. HINT: This symptom may occur for any of the windows. CAUTION ...

    Installation
    INSTALLATION PROCEDURE 1. REMOVE MONOLITHIC CONVERTER PROTECTOR (a) Install the upper monolithic converter protector and lower monolithic converter protector with the 2 bolts and 2 nuts. Torque: 11 N·m {107 kgf·cm, 8 ft·lbf} (b) Install the clamp with the bolt as shown in the ...