TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Supplemental Restraint Systems / Driver Side Knee Airbag Assembly / On-vehicle Inspection

Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 1 instrument panel airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 1 instrument panel airbag assembly with a new one:

Cuts, minute cracks or marked discoloration on the lower No. 1 instrument panel airbag assembly.

2. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag has not Deployed)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 1 instrument panel airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 1 instrument panel airbag assembly with a new one:

  • Cuts, minute cracks or marked discoloration on the lower No. 1 instrument panel airbag assembly.
  • Cracks or other damage to the connector.
  • Deformation or cracks on the instrument panel reinforcement.

CAUTION:

For removal and installation procedures of the lower No. 1 instrument panel airbag assembly, be sure to follow the correct procedure.

    Related Tacoma materials

    Parts Location
    PARTS LOCATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

    Open in One Side of Bus 3 Branch Line
    DESCRIPTION When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Ch ...

    IG2 Signal Malfunction (B2788)
    DESCRIPTION This DTC is stored when the steering lock ECU (steering lock actuator or UPR bracket assembly) detects an IG2 power supply malfunction. HINT: The steering lock ECU (steering lock actuator or UPR bracket assembly) is not connected to the CAN communication system. However, the steer ...