Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection - Refrigerant(for Hfc-134a(r134a))

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT REFRIGERANT PRESSURE WITH MANIFOLD GAUGE SET

(a) This is a method to specify trouble areas by using a manifold gauge set. Read the manifold gauge pressure when the following conditions are established.

Test conditions:

Engine has been warmed up.
All doors are fully open.
A/C switch is ON.
Engine is running at 1,500 rpm.
Air inlet mode selector damper is set at recirculation.
Temperature control switch is in MAX. COLD position.
Blower speed control switch is in HI position.
Air temperature at the air inlet is 30 to 35°C (86 to 95°F).

Gauge readings (Reference)

(1) When the refrigerant volume is proper:

Gauge reading:

Low pressure side:

150 to 250 kPa (1.5 to 2.5 kgf/cm2, 22 to 36 psi)

High pressure side:

1370 to 1570 kPa (14.0 to 16.0 kgf/cm2, 199 to 228 psi)

(2) When there is moisture in the refrigeration system:

Symptoms	Probable Cause	Diagnosis	Corrective Actions
During operation, pressure on low pressure side cycles between normal and vacuum	Moisture in refrigeration system freezes at expansion valve orifice, causing temporary stop of cycle. However, when melted, normal state restored	Drier overly saturated Moisture in refrigeration system freezes at expansion valve orifice and blocks refrigerant circulation	Remove moisture from cycle by repeatedly evacuating air Supply appropriate volume of new refrigerant

(3) When cooling is insufficient:

Symptoms	Probable Cause	Diagnosis	Corrective Actions
Pressure low on both low and high pressure sides Cooling performance insufficient	Gas leakage from refrigeration system	Insufficient refrigerant Refrigerant leakage	Check for gas leakage and repair if necessary Supply appropriate volume of new refrigerant If indicated pressure value close to 0 when connected to gauge, create vacuum after inspecting and repairing the location of leakage

(4) When the circulation of the refrigerant is poor:

Symptoms	Probable Cause	Diagnosis	Corrective Action
Pressure low on both low and high pressure sides Frost exists on piping from condenser to A/C unit	Refrigerant flow obstructed by dirt in condenser	Condenser clogged	Replace condenser

(5) When the refrigerant does not circulate:

Symptoms	Probable Causes	Diagnosis	Corrective Actions
Vacuum indicated on low pressure side, and extremely low pressure indicated on high pressure side Frost or condensation seen on piping on both sides of condenser or expansion valve	Refrigerant flow obstructed by moisture or dirt in refrigeration system Refrigerant flow obstructed by gas leakage from expansion valve	Refrigerant does not circulate	Check expansion valve Clean expansion valve by blowing air Replace condenser Evacuate air and charge appropriate volume of new refrigerant For gas leakage from expansion valve, replace expansion valve

(6) When the refrigerant is overcharged or cooling of condenser is insufficient:

Symptoms	Probable Causes	Diagnosis	Corrective Actions
Pressure extremely high on both low and high pressure sides	Excessive refrigerant Cooling performance of condenser insufficient	Excessive refrigerant Cooling performance of condenser insufficient	Clean condenser Check condenser fan motor operation If 1 and 2 normal, check the amount of refrigerant and supply appropriate volume of refrigerant

(7) When there is air in the refrigeration system:

Symptoms	Probable Cause	Diagnosis	Corrective Actions
Pressure extremely high on both low and high pressure sides The low pressure piping too hot to touch	Air in refrigeration system	Air in refrigeration system Vacuum purging insufficient	Check whether compressor oil dirty or insufficient Evacuate air and charge new refrigerant

(8) When the expansion valve malfunctions:

Symptoms	Probable Cause	Diagnosis	Corrective Action
Pressure extremely high on both low and high pressure sides Frost or condensation on piping on low pressure side	Trouble in expansion valve	Excessive refrigerant in low pressure piping Expansion valve too wide open	Replace expansion valve

(9) When the compressor is defective:

Symptoms	Probable Cause	Diagnosis	Corrective Action
Pressure extremely high on both low and high pressure sides Pressure extremely low on high pressure side	Internal leakage in compressor	Compression failure Leakage from damaged valve or broken sliding parts	Repair or replace compressor

Refrigerant(for Hfc-134a(r134a))

...

Replacement

REPLACEMENT PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (a) Start up the engine. (b) Turn the A/C switch to ON. (c) Operate the cooler compressor with an engine speed of approximat ...

Refrigerant(for Hfc-134a(r134a))

Replacement

Related Tacoma materials