Toyota Tacoma (2015-2018) Service Manual: Noise Occurs or Sound Skips when Portable Player Plays
CAUTION / NOTICE / HINT
HINT:
- Perform this check with the portable player volume set at an appropriate level.
- Make sure that there are no obstructions between the portable player and radio and display receiver assembly that may block signals, and that the portable player and radio and display receiver assembly are not excessively far apart.
- Make sure that devices other than the radio and display receiver assembly are not connected to the portable player.
- Make sure that there is no interference from a wireless LAN, etc.
PROCEDURE
|
1. |
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check that the same problem does not occur in the sound heard from the speakers on another "Bluetooth" audio compatible vehicle of the same model.
OK:
The same problem does not occur in the sound heard from the speakers.
| NG | .gif) |
MALFUNCTION IN PORTABLE PLAYER |
|
.gif)
|
2. |
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Play the portable player and check that the same problem does not occur in the sound heard from the speakers.
OK:
The same problem does not occur in the sound heard from the speakers.
| OK | |
END |
| NG | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Portable Player cannot be Operated Using In-vehicle Device or Track Information
is not Displayed on In-vehicle Device
PROCEDURE
1.
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL
(a) Check if track information is displayed normally on another "Bl ...
Portable Player cannot be Connected Manually/Automatically
CAUTION / NOTICE / HINT
HINT:
Some versions of "Bluetooth" compatible audio players may not function, or the
function may be limited using the radio and display receiver assembly, even i ...
Other materials:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is stored during the DTC check, inspect the trouble areas listed
for that code. For details of the code, refer to "See page" below.
Transponder Key ECU Assembly
DTC Code
Detection Item
See page
...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE REAR BUMPER HOLE COVER
(a) Disengage the 2 clips to remove the rear bumper hole cover.
2. REMOVE REAR BUMPER PAD SUB-ASSEMBLY
(a) Separate the 2 license plate light assemblies as shown in the illustr ...
Oil Pressure Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Disengage the clamp and disconnect the engine oil pressure switch
connector.
(b) Using a 24 mm deep socket ...
