TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Rc62f Manual Transmission / Transaxle / Manual Transmission Oil

Toyota Tacoma (2015-2018) Service Manual: Manual Transmission Oil

Components

COMPONENTS

ILLUSTRATION

On-vehicle Inspection

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT MANUAL TRANSMISSION OIL

(a) Park the vehicle on a level surface.

(b) Remove the transmission filler plug and gasket.

(c) Check that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the filler plug opening.

Text in Illustration

*a

0 to 5.0 mm (0 to 0.196 in.)

If the result is not as specified, add transmission oil.

Manual transmission oil:

Oil grade

Oil viscosity

Standard capacity

Gear oil API GL-3 (GL-4)

SAE 75W-90

2.5 liters (2.6 US qts, 2.2 Imp. qts)

NOTICE:

  • Too much or too little oil will lead to transmission problems.
  • After adjusting the oil level, drive the vehicle and check the oil level again.

(d) Inspect for oil leaks when the oil level is low.

(e) Install a new gasket and the transmission filler plug.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

Replacement

REPLACEMENT

PROCEDURE

1. DRAIN MANUAL TRANSMISSION OIL

(a) Remove the manual transmission filler plug and gasket.

(b) Remove the drain plug sub-assembly and gasket and then drain the manual transmission oil.

(c) Install a new gasket and the drain plug sub-assembly.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

2. ADD MANUAL TRANSMISSION OIL

(a) Add manual transmission oil until the oil level is within 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the manual transmission filler plug opening.

Text in Illustration

*a

0 to 5.0 mm (0 to 0.196 in.)

Manual transmission oil:

Oil grade

Oil viscosity

Standard capacity

Gear oil API GL-3 (GL-4)

SAE 75W-90

2.5 liters (2.6 US qts, 2.2 Imp. qts)

3. INSPECT MANUAL TRANSMISSION OIL

Manual Transmission System

    Related Tacoma materials

    Tonneau Cover Assembly
    Removal REMOVAL PROCEDURE 1. REMOVE TOP COVER SUB-ASSEMBLY (a) Open the cover. (b) Remove the bolt and top cover sub-assembly. 2. REMOVE REAR BODY SIDE PANEL PROTECTOR Click here Installation INSTALLATION PROCEDURE 1. INSTALL REAR ...

    Compass (vehicles with auto anti-glare inside rear view mirror)
    The compass on the inside rear view mirror indicates the direction in which the vehicle is heading. ■ Operation Type A To turn the compass on or off, press the button. Type B ■ Displays and directions Calibrating the compass The direction display deviates from the true ...

    On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AIR CONDITIONER PRESSURE SENSOR (for Automatic Air Conditioning System) (a) Check the wire harness. (1) Disconnect the A34 air conditioner pressure sensor connector. (2) Disconnect the A35 and A36 air conditioning amplifier assembly connector. ...