DESCRIPTION
These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-collision system control.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
U0100 |
Lost Communication with ECM / PCM "A" |
When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the ECM and millimeter wave radar sensor assembly is detected for approximately 4 seconds. |
|
|
U0125 |
Lost Communication with Yaw Rate Sensor Module |
When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the yaw rate sensor (airbag sensor assembly) and millimeter wave radar sensor assembly is detected for approximately 1 second. |
|
|
U0126 |
Lost Communication with Steering Angle Sensor Module |
When the ignition switch is ON, a communication error between the steering angle sensor (spiral cable with sensor sub-assembly) and millimeter wave radar sensor assembly is detected for approximately 1 second. |
|
|
U0129 |
Lost Communication with Brake System Control Module |
When the ignition switch is ON, a communication error between the skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 and millimeter wave radar sensor assembly is detected for approximately 6 seconds. |
|
- *1: for Hydraulic Brake Booster
- *2: for Vacuum Brake Booster
PROCEDURE
|
1. |
CHECK FOR DTCs (PRE-COLLISION SYSTEM) |
(a) Clear the DTCs.
Click here .gif)
(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Click here
|
Result |
Proceed to |
|---|---|
|
DTC U0100, U0125, U0126 and U0129 are not output |
A |
|
DTC U0100, U0125, U0126 or U0129 is output |
B |
| A | .gif) |
USE SIMULATION METHOD TO CHECK |
| B | |
GO TO CAN COMMUNICATION SYSTEM |
