TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Pre-collision / Pre-collision System / Heater Circuit (C1AAE)

Toyota Tacoma (2015-2018) Service Manual: Heater Circuit (C1AAE)

DESCRIPTION

If the forward recognition camera detects a malfunction in the camera heater (forward recognition hood) circuit, it will output a malfunction signal to the millimeter wave radar sensor assembly via CAN communication and DTC C1AAE will be stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AAE

Heater Circuit

When the ignition switch is ON, the millimeter wave radar sensor assembly receives a camera heater (forward recognition hood) circuit malfunction signal from the forward recognition camera continuously for 5 seconds or more.

Forward recognition camera system

PROCEDURE

1.

GO TO FORWARD RECOGNITION CAMERA SYSTEM

HINT:

If DTC C1AAE is output by the pre-collision system, perform troubleshooting for the forward recognition camera system.

Click here

NEXT

END
    Related Tacoma materials

    Fuel Main Valve
    Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY (See page ) 2. REMOVE FUEL SENDER GAUGE ASSEMBLY 3. REMOVE NO. 1 FUEL SUB-TANK 4. REMOVE FUEL PUMP FILTER 5. REMOVE FUEL MAIN VALVE ASSEMBLY (a) Remove t ...

    Transfer Case Rear Oil Seal
    Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. DRAIN TRANSFER OIL 2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (See page ) 3. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY 4. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL ( ...

    Illumination for Panel Switch does not Come on with Tail Switch ON
    PROCEDURE 1. CHECK VEHICLE SIGNAL (OPERATION CHECK) (a) Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (See page ). (b) Check that the display changes between ON and OFF according to the light control ...