Toyota Tacoma (2015-2018) Service Manual: Jam Protection Function does not Operate

Toyota Tacoma (2015-2018) Service Manual / Window / Glass / Power Window Control System(w/ Jam Protection Function) / Jam Protection Function does not Operate

DESCRIPTION

This symptom may occur for any of the windows.

The jam protection function operates within a specified range during the manual up or auto up operation.

CAUTION / NOTICE / HINT

NOTICE:

If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page ).
If the pulse sensor built into the power window regulator motor assemblies is malfunctioning, the power window control system enters fail-safe mode. The jam protection function cannot be operated during fail-safe mode (See page ).
After the jam protection function operates when an auto up or manual up operation is performed, the jam protection function will not operate when the manual up operation is performed again within approximately 4 seconds.
After the catch protection function operates when an auto down or manual down operation is performed, the jam protection function will not operate when the manual down operation is performed again within approximately 4 seconds.

PROCEDURE

1.	PERFORM INITIALIZATION (APPLICABLE LOCATION)

(a) Initialize the power window regulator motor assembly (applicable location) (See page ).

2.	CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)

(a) Check if the power window auto up/down function operates normally (See page OK: OK: ).

OK:

Auto up/down function is normal.

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

3.	CHECK JAM PROTECTION FUNCTION OPERATING RANGE

(a) Check if the jam protection function operates normally for the applicable power window.

HINT:

The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

OK:

Jam protection function operates normally.

Result

Result	Proceed to
OK	A
NG (Driver side power window)	B
NG (Front passenger side power window)	C

END (PROBLEM DUE TO INITIALIZATION FAILURE)

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

DESCRIPTION If a door glass or a power window regulator motor assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function bei ...

Power Window Control System(w/o Jam Protection Function)

...

Other materials:

Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment. PROCEDURE 1. PRECAUTION ...

ECU Malfunction (B1003)
DESCRIPTION DTC No. DTC Detection Condition Trouble Area B1003 A malfunction in the non-volatile storage of the central gateway ECU (network gateway ECU) is detected. Central gateway ECU (network gateway ECU) PROC ...

Terminals Of Ecm
TERMINALS OF ECM 1. ECM HINT: The standard voltage between each pair of ECM terminals is shown in the table below. In the table, first follow the information under "Condition". Look under "Terminal No. (Symbol)" for the terminals to be inspected. The standard voltage b ...