Toyota Tacoma (2015-2018) Service Manual: Inverter Relay

Toyota Tacoma (2015-2018) Service Manual / Other System / Inverter Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT INVERTER RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 5	Voltage is not applied between terminals 1 and 2	10 kΩ or higher
3 - 5	Voltage is applied between terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the inverter relay.

Other System

...

Power Outlet Socket(for Front Side)

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL (See page ) 2. REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY (a ...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT CLUTCH DISC ASSEMBLY NOTICE: When replacing the clutch disc assembly, make sure to perform an inspection of the flywheel sub-assembly and clutch cover assembly. (a) Using a vernier caliper, measure the rivet depth. Minimum rivet depth: 0.3 mm ...

Lost Communication with Cruise Control Front Distance Range Sensor (U0235)
DESCRIPTION The millimeter wave radar sensor assembly is connected to the skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 via CAN communication. If communication with the skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake act ...

Hazard Warning Switch Circuit
DESCRIPTION The combination meter assembly receives information signals from the telltale light assembly (hazard warning signal switch). WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedur ...