Toyota Tacoma (2015-2018) Service Manual: Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY (for Driver Side)
(a) Set the front seat cushion heater assembly so that the name stamp side facing is on the front seat cushion pad side.
(b) Install the front seat cushion heater assembly with 16 new tag pins.
2. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY (for Front Passenger Side)
(a) Set the front seat cushion heater assembly so that the name stamp side facing is on the front seat cushion pad side.
(b) Install the front seat cushion heater assembly with 17 new tag pins.
3. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER (for Front Passenger Side)
(See page .gif)
)
4. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER (for Driver Side)
(See page )
5. INSTALL FRONT SEAT ASSEMBLY (for Front Passenger Side)
(See page )
6. INSTALL FRONT SEAT ASSEMBLY (for Driver Side)
(See page )
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY (for Driver Side)
(See page )
2. REMOVE FRONT SEAT ASSEMBLY (for Front Passenger Side)
(See page )
3. REMOVE SEPARATE TYPE FRONT SEAT CUSHION CO ...
Other materials:
Route cannot be Calculated
PROCEDURE
1.
SET DESTINATION
(a) Set another destination and check if the system can calculate the route correctly.
OK:
Route can be correctly calculated.
OK
NORMAL OPERATION
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN ...
Sleep Operation Failure of Occupant Classification ECU (B1796)
DESCRIPTION
During sleep mode, the occupant detection ECU monitors the condition of each
sensor while the ignition switch is off. In this mode, if the occupant detection
ECU detects an internal malfunction, DTC B1796 is set.
DTC No.
DTC Detections Conditions
Tr ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WIPER ARM HEAD CAP
(a) Using a screwdriver with its tip wrapped in protective tape, disengage
the 3 claws to remove the front wiper arm head cap.
Text in Illustration
*a
Protective Tape
HINT ...
