TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Air Conditioning / Air Conditioning Panel(for Automatic Air Conditioning System) / Installation

Toyota Tacoma (2015-2018) Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSFER POSITION SWITCH (for 4WD)

Click here 2. INSTALL ENGINE SWITCH

2. INSTALL ENGINE SWITCH

Click here 3. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

3. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

(a) Connect the connectors.

(b) Engage the 8 clips to install the air conditioning control assembly.

4. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)

Click here 5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

Click here 6. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

6. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

Click here 7. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

7. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click here 8. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

8. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

Click here 9. INSTALL COWL SIDE TRIM BOARD LH

9. INSTALL COWL SIDE TRIM BOARD LH

Click here 10. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab)

10. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab)

Click here 11. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab)

11. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab)

Click here Removal

    Related Tacoma materials

    Acceleration Sensor Internal Circuit (C1419,C1435)
    DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. If t ...

    Master Module Horizontal Axis Misalignment (C1AC1)
    DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT: If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor ...

    Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas ...