TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Fuel / Fuel Pressure Sensor

Toyota Tacoma (2015-2018) Service Manual: Fuel Pressure Sensor

Components

COMPONENTS

ILLUSTRATION

Inspection

Inspection

INSPECTION

PROCEDURE

1. INSPECT FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR)

NOTICE:

  • Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly.
  • If a fuel pressure sensor is removed, replace the fuel delivery pipe sub-assembly with a new one.

(a) Remove the fuel delivery pipe sub-assembly (See page (b) Check the fuel pressure sensor output voltage. ).

(b) Check the fuel pressure sensor output voltage.

(1) Apply 5 V between terminals 1 (VC) and 3 (E2).

Text in Illustration

*a

Component without harness connected

(Fuel Pressure Sensor)

*b

Voltage applied between terminals

NOTICE:

  • Be careful when connecting the leads, as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
  • Do not apply more than 6 V to terminals 1 (VC) and 3 (E2).

HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.

(2) Measure the voltage between terminals.

Text in Illustration

*a

Component without harness connected

(Fuel Pressure Sensor)

Standard Voltage:

Tester Connection

Condition

Specified Condition

2 (PFL) - 3 (E2)

Pressure not applied to fuel pressure sensor

Approximately 0.56 to 0.94 V

If the result is not as specified, replace the fuel delivery pipe sub-assembly.

(c) Install the fuel delivery pipe sub-assembly (See page Installation ).

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the fuel delivery pipe sub-assembly (fuel pressure sensor) (See page PROCEDURE ).

PROCEDURE

1. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR)

(See page )

NOTICE:

  • Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly.
  • If a fuel pressure sensor is removed, replace the fuel delivery pipe sub-assembly (fuel pressure sensor) with a new one.

HINT:

Perform "Inspection After Repairs" after replacing the fuel delivery pipe sub-assembly (fuel pressure sensor) (See page Removal ).

Removal

REMOVAL

PROCEDURE

1. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR)

(See page )

NOTICE:

  • Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly.
  • If a fuel pressure sensor is removed, replace the fuel delivery pipe sub-assembly (fuel pressure sensor) with a new one.
    Related Tacoma materials

    Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE REAR AXLE SHAFT SNAP RING (a) Using a snap ring expander, remove the snap ring. 2. REMOVE REAR AXLE SHAFT (a) Using SST and press, remove the rear axle shaft. SST: 09521-25011 SST: 09521-25021 3. REMOVE REAR AXLE BEARING RETAINER INNER (a) Remove the rear ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the fuel injector assembly (See page ). PROCEDURE 1. INSTALL FUEL INJECTOR ASSEMBLY HINT: Perform "Inspection After Repairs" after replacing the fuel injector assembly (See p ...

    Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART Forward Recognition Camera System DTC No. Detection Item Link C1A0A Front Radar Sensor Region Code Mismatch C1A47 Steering Angle Sensor ...