TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Clutch / Clutch Start Cancel Switch

Toyota Tacoma (2015-2018) Service Manual: Clutch Start Cancel Switch

Inspection

INSPECTION

PROCEDURE

1. INSPECT CLUTCH START CANCEL SWITCH ASSEMBLY

(a) Using an ohmmeter, check that there is resistance between terminals 2 and 4.

Standard:

10 kΩ or higher

If the result is not as specified, replace the clutch start cancel switch.

(b) Connect the positive (+) lead from the battery to terminal 3 and connect negative (-) lead to terminal 1.

(c) Using an ohmmeter, check that there is resistance between terminals 2 and 4.

Standard:

10 kΩ or higher

If the result is not as specified, replace the clutch start cancel switch.

(d) Check that the indicator light comes on and there is resistance between terminals 2 and 4 when the switch is pressed.

Standard:

Below 1 Ω

If the result is not as specified, replace the clutch start cancel switch.

(e) Using an ohmmeter, check that there is resistance between terminals 2 and 4 when the battery lead is disconnected.

Standard:

10 kΩ or higher

If the result is not as specified, replace the clutch start cancel switch.
    Related Tacoma materials

    Parking Sensor Display and Object Distance
     Detection range of the sensors Approximately 3.3 ft. (100 cm) Approximately 4.9 ft. (150 cm) Approximately 2.0 ft. (60 cm) The diagram illustrates the approximate areas covered by the intuitive parking assist sensors around the Toyota Tacoma. Objects located within these areas may be de ...

    Compressor Lock Sensor Circuit (B1422)
    SYSTEM DESCRIPTION The ECM sends the engine speed signal to the air conditioning amplifier assembly via CAN communication. The air conditioning amplifier assembly reads the difference between compressor speed and engine speed. When the difference becomes too large, the air conditioning ampli ...

    Pressure Control Solenoid "C" Circuit Open (P079513)
    DESCRIPTION Changing from 1st to 6th is performed by the ECM turning shift solenoid valves SL1, SL2, SL3 and SL4 on and off. If an open or short circuit occurs in any of the shift solenoid valves, the ECM controls the remaining normal shift solenoid valves to allow the vehicle to be operated ...