Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Engine Control System Malfunction (C1201)

DESCRIPTION

If a malfunction in the engine control system is detected, VSC and TRAC operations are prohibited by the fail-safe function.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1201

Engine Control System Malfunction

A malfunction signal is received from the ECM.

Engine control system

PROCEDURE

1.

CHECK DTC (ENGINE CONTROL SYSTEM)

(a) Check if any engine control system DTC is output.

Result

Result

Proceed to

DTC is not output

A

DTC is output

B

A

USE SIMULATION METHOD TO CHECK

B

GO TO ENGINE CONTROL (DIAGNOSTIC TROUBLE CODE CHART)

SM Solenoid Circuit (C1225,C1468,C1469,C146A,C146B)
DESCRIPTION These solenoids turn on when signals are received from the skid control ECU (brake actuator assembly) and they control the pressure acting on the wheel cylinders to control the brakin ...

ECM Communication Circuit Malfunction (C1203)
DESCRIPTION The circuit is used to send TRAC and VSC control information from the skid control ECU (brake actuator assembly) to the ECM, and engine control information from the ECM to the skid co ...

Other materials:

System Description
SYSTEM DESCRIPTION 1. ENGINE IMMOBILISER SYSTEM DESCRIPTION The engine immobiliser system is designed to prevent the vehicle from being stolen. This system uses the transponder key ECU assembly that stores the key ID codes of authorized ignition keys. If an attempt is made to start the engine ...

Driver Side Door Entry Lock Function does not Operate
DESCRIPTION If the entry lock function does not operate for the driver door only, but the entry unlock function operates, the request code is being transmitted properly from the driver door. In this case, there may be a problem related to the front door outside handle assembly LH (lock sensor ...

Rear Door Black Out Tape
Components COMPONENTS ILLUSTRATION Installation INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REPAIR INSTRUCTION 2. INSTALL NO. 2 BLACK OUT TAPE (a) Refer ...

В© 2011-2026 Copyright www.ttguide.net