Toyota Tacoma (2015-2018) Service Manual: Dtc Check / Clear

HINT:

• Refer to Audio and Visual System (w/o Navigation System) (See page ).
• Refer to Navigation System (w/ Navigation System) (See page ).

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Rear View Monitor System DTC Code Detection Item See page C1622 Open or Short Circuit in Back Camera Signal ...

Open or Short Circuit in Back Camera Signal (C1622)

DESCRIPTION This DTC is stored if the radio and display receiver assembly*1 or navigation receiver assembly*2 judges as a result of its self check that the signals or signal lines between the rad ...

Other materials:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART If a DTC is displayed during the DTC check, check the parts listed in the table below and proceed to the "See page" given. *1: "Comes on" means the Malfunction Indicator Lamp (MIL) illuminates. *2: "DTC stored" means ...

Installation
INSTALLATION PROCEDURE 1. INSTALL COOLER CONDENSER ASSEMBLY (a) Engage the 2 claws to install the 2 condenser upper brackets. (b) Engage the 2 claws to install the 2 condenser lower brackets. (c) Lift the cooler condenser assembly up from the rear side of the vehicle, and install ...

Main Switch Circuit
DESCRIPTION When the blind spot monitor main switch assembly (warning canceling switch assembly) is turned on, a signal is sent to the blind spot monitor sensor LH. The blind spot monitor system operates according to this signal. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the ...