Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Diagnosis System

DIAGNOSIS SYSTEM

1. CHECK DLC3

(a) Check the DLC3 (See page 2. INSPECT BATTERY VOLTAGE ).

2. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials:

Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE REAR SEAT CUSHION BAND (a) Remove the screw and rear seat cushion band. 2. REMOVE REAR SEAT HEADREST HO ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR AXLE SHAFT SNAP RING (a) Using a snap ring expander, remove the snap ring. 2. REMOVE REAR AXLE SHAFT (a) Using SST and press, remove the rear axle shaft. SST: 09521-25011 SST: 09521-25021 3. REMOVE REAR AXLE BEARING RETAINER INNER (a) Remove the rear ...

Installation
INSTALLATION PROCEDURE 1. INSTALL COOLER CONDENSER ASSEMBLY (a) Engage the 2 claws to install the 2 condenser upper brackets. (b) Engage the 2 claws to install the 2 condenser lower brackets. (c) Lift the cooler condenser assembly up from the rear side of the vehicle, and install ...

В© 2011-2026 Copyright www.ttguide.net