Toyota Tacoma (2015-2018) Service Manual: Customize Parameters
CUSTOMIZE PARAMETERS
1. CUSTOMIZE METER / GAUGE SYSTEM
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Warning or Display.
(5) Select the setting by referring to the table below.
NOTICE:
Record the current settings before customizing.
Warning|
Display |
Default |
Content |
Setting |
Relevant ECU |
|---|---|---|---|---|
|
Key Remind Volume |
Large |
Function to change the volume of the key reminder buzzer. |
Large,Medium,Small |
Combination meter assembly |
|
Key Remind Sound |
Normal |
Function to change the frequency of the key reminder buzzer. |
Normal,Slow,Fast |
Combination meter assembly |
|
Display |
Default |
Content |
Setting |
Relevant ECU |
|---|---|---|---|---|
|
ODO Display Time After IG OFF Setting |
30s |
Function to change the ODO Display Time After IG OFF Setting. |
30s,60s,600s,OFF |
Combination meter assembly |
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are u ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the combination meter.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
...
Other materials:
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
*1
COMPRESSOR PICK UP SENSOR
*2
MAGNET CLUTCH ASSEMBLY
*3
PRESSURE RELIEF VALVE
*4
COMPRESSOR SPACER
*5
O-RING
...
Door Unlock Detection Switch Circuit
DESCRIPTION
The main body ECU (multiplex network body ECU) detects the condition of each
door unlock detection switch.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
If the main body ECU (multiplex network body ECU) is replaced, refer to Registration
(See page ).*1
*1: w/ Smart K ...
Driver Side Door Entry Unlock Function does not Operate
DESCRIPTION
If the entry unlock function does not operate for the driver door only, but the
entry lock function operates, the request code is being transmitted properly from
the driver door. In this case, there may be a problem related to the touch sensor
(connection between the certification ...
