Toyota Tacoma (2015-2018) Service Manual: Customize Parameters
CUSTOMIZE PARAMETERS
1. LANE DEPARTURE ALERT SYSTEM
Click here 
2. INTUITIVE PARKING ASSIST SYSTEM
Click here
3. PRE-COLLISION SYSTEM
Click here
4. SEAT BELT WARNING SYSTEM
Click here
5. AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)
Click here
6. THEFT DETERRENT SYSTEM
Click here
7. LIGHTING SYSTEM
Click here
8. POWER DOOR LOCK CONTROL SYSTEM
Click here
9. WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System)
Click here
10. WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)
Click here
11. SMART KEY SYSTEM (for Entry Function)
Click here
12. KEY REMINDER WARNING SYSTEM
Click here
13. METER / GAUGE SYSTEM
Click here
14. POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)
Click here
15. SLIDING ROOF SYSTEM
Click here
Vehicle Lift And Support Locations
VEHICLE LIFT AND SUPPORT LOCATIONS
1. NOTICE ABOUT VEHICLE CONDITION WHEN JACKING UP VEHICLE
(a) The vehicle must be unloaded before jacking up / lifting up the vehicle.
Never jack up / lift up a ...
Initialization
INITIALIZATION
1. PROCEDURES NECESSARY WHEN BATTERY TEMINAL IS DISCONNECTED/RECONNECTED
Necessary Procedure
Effect/Inoperative Function when Necessary Procedures are not Perfor ...
Other materials:
Short in Driver Side Knee Airbag Squib Circuit (B1860/64-B1863/64)
DESCRIPTION
The driver side knee airbag squib circuit consists of the airbag sensor assembly
and lower No. 1 instrument panel airbag assembly.
The airbag sensor assembly uses this circuit to deploy the airbag when deployment
conditions are met.
These DTCs are stored when a malfunction is dete ...
Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here
FUNCTION OF WARNING INDICATOR AND MESSAGE
(a) If the pre-collision system is not functioning properly, the driver is warned
by the PCS warning light and a warning message displayed on the multi-information
display.
Mas ...
Initialization
INITIALIZATION
1. ZERO POINT CALIBRATION
NOTICE:
Make sure that the front passenger seat is not occupied before performing the
operation.
HINT:
Perform the zero point calibration and sensitivity check if any of the following
conditions apply.
The occupant detection ECU is replaced. ...
