Toyota Tacoma (2015-2018) Service Manual: Components

Front Axle Hub

...

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE KNUCKLE GREASE RETAINER CAP (for 2WD) (a) Using a screwdriver and hammer, remove the knuckle grease retainer cap. 2. REMOVE FRONT AXLE HUB OIL SEAL (for 4WD) ( ...

Other materials:

Unable to Unlock Steering Wheel (Engine cannot Start)
DESCRIPTION The steering lock actuator assembly activates the steering lock motor and moves the lock bar into the steering column to lock the steering. The steering may not unlock when the lock bar gets stuck in the lock hole of the steering column. In this case, if the engine switch is turned ...

Dtc Check / Clear
DTC CHECK / CLEAR NOTICE: When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data. HINT: DTCs which are sto ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. When installing a new front fender wheel opening moulding or quarter panel wheel opening moulding, heat the vehicle body and front fender ...