Installation
INSTALLATION
PROCEDURE
1. INSTALL BRAKE PEDAL PAD
(a) Install the brake pedal pad onto the brake pedal.
2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
(a) Install the brake pedal support assembly with ...
Precaution
PRECAUTION
1. Necessary care must be taken to replace each part properly as it could affect
the brake system performance. This could cause driving hazards. Replace each part
with an identical par ...
Related Tacoma materials
Illumination for Panel Switch does not Come on with Tail Switch ON
PROCEDURE
1.
CHECK VEHICLE SIGNAL (OPERATION CHECK)
(a) Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal
in Operation Check (See page ).
(b) Check that the display changes between ON and OFF according to the light
control ...
Starter Relay
Inspection
INSPECTION
PROCEDURE
1. INSPECT STARTER RELAY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Connection
Specified Condition
3 - 5
...
Engine Compartment Checks and Service Points
Components
Fuse boxes
Battery
Engine oil filler cap
Engine coolant reservoir
Engine oil level dipstick
Brake fluid reservoir
Washer fluid tank
Intercooler
Cooling fan
Condenser
Radiator
Checking the engine oil
Check the engine oil level with the engine at normal operating temperature ...