DESCRIPTION
This DTC is stored when the blind spot monitor sensor LH detects an internal malfunction.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
C1AB6 |
The blind spot monitor sensor LH (master) detects an internal malfunction. |
Blind spot monitor sensor LH |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page
).
(b) Recheck for DTCs and check if the same DTC is output again (See page
).
OK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK |
| NG | |
REPLACE BLIND SPOT MONITOR SENSOR LH |
Open in Outer Mirror Indicator(Slave) (C1AB5)
Open in Outer Mirror Indicator(Master) (C1AB4)Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary
notices concerning the SRS airbag system before servicing (See page
).
HINT:
Use the same procedure for the LH side and RH side.
The procedure listed be ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
If a problem occurs in certain locations or at certain times of day,
check for the possibility of wave interference.
When the electrical key transmitter sub-assembly is brought near the
electrical key and TPMS receiver assembly (RF band), front outs ...