Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
|
(a) Measure the resistance according to the value(s) in the table below. Text in Illustration
Standard Resistance:
If the result is not as specified, replace the back-up light switch assembly. |
|
Removal
REMOVAL
PROCEDURE
1. REMOVE SHIFT LEVER BOOT ASSEMBLY
2. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY
|
(a) Disconnect the connector. |
|
|
(b) Detach the 4 clamps. |
|
|
(c) Using SST, remove the back-up light switch assembly and gasket from the transmission case. SST: 09817-16011 |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY
|
(a) Using SST, install a new gasket and the back-up light switch assembly to the transmission case. SST: 09817-16011 Torque: 44 N·m {449 kgf·cm, 32 ft·lbf} |
|
(b) Attach the 4 clamps.
(c) Connect the connector.
2. INSTALL SHIFT LEVER BOOT ASSEMBLY

