Toyota Tacoma (2015-2018) Service Manual: A/C ECU Vehicle Information Reading/Writing Processor Malfunction (B15F5)
DESCRIPTION
This DTC is stored when items controlled by the air conditioning amplifier assembly cannot be customized via the audio and visual system vehicle customization screen.
HINT:
The air conditioning amplifier assembly controls the air conditioning system related items that are customizable via the audio and visual system vehicle customization screen.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B15F5 |
Air conditioning amplifier assembly vehicle setting processing malfunction |
|
PROCEDURE
|
1. |
CHECK CAN COMMUNICATION SYSTEM |
(a) Use the Techstream to check if the CAN communication system is functioning
normally (See page .gif)
).
OK:
CAN communication DTCs are not output.
| NG | .gif) |
GO TO CAN COMMUNICATION SYSTEM |
|
.gif)
|
2. |
CHECK AIR CONDITIONING SYSTEM |
(a) Check if the air conditioning system is malfunctioning (See page
).
HINT:
Customization may not be possible depending on the malfunction in the air conditioning system.
OK:
No malfunctions are present in the air conditioning system.
| NG | |
GO TO AIR CONDITIONING SYSTEM |
|
|
3. |
CHECK CUSTOMIZE ITEMS |
(a) Make a note of the customizable items for the air conditioning system.
HINT:
The items shown as customizable via the audio and visual system vehicle customization screen can also be changed using the Techstream. In the following step, the Techstream will be used.
(1) To match-up the items on the audio and visual system vehicle customization
screen with the items on the Techstream, check the customize parameters list for
the air conditioning system related items that can be customized via the audio and
visual system vehicle customization screen (See page
).
(b) Using the Techstream, confirm that it is possible to change the settings of the air conditioning system related customize parameters that are shown as customizable via the audio and visual system vehicle customization screen.
OK:
The items available for customization via the audio and visual system vehicle customization screen can be customized successfully using the Techstream.
| OK | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
| NG | |
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY |
Speaker Output Short (B15C3)
DESCRIPTION
This DTC is stored when a malfunction occurs in the speakers.
DTC No.
DTC Detection Condition
Trouble Area
B15C3
A short is d ...
Main Body ECU Vehicle Information Reading/Writing Process Malfunction (B15F6)
DESCRIPTION
This DTC is stored when items controlled by the main body ECU (multiplex network
body ECU) cannot be customized via the audio and visual system vehicle customization
screen.
HINT: ...
Other materials:
Air Fuel Ratio Sensor
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
(a) Disconnect the air fuel ratio sensor connector.
(b) Disengage the clamp to separate the air fuel ratio sensor wire ...
Pressure Control Solenoid "A" Actuator Stuck Off (P07457F)
SYSTEM DESCRIPTION
The ECM uses the vehicle speed signal and signals from the transmission revolution
sensors (NT, SP2) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear).
The ECM compares the actual gear with the shift schedule in the ECM memory to
detect mechanical problems of t ...
System Description
SYSTEM DESCRIPTION
1. FRONT SEAT HEATER
(a) By operating the seat heater switch on the air conditioning control assembly,
the temperature can be controlled within the range of 36 to 42.2°C (96 to 108°F).
(b) The on/off status and heater level of each seat heater are indicated by the
respect ...
