PROCEDURE
|
1. |
CHECK CONDITION |
(a) Check if the system voice recognition level is low when recognizing a particular voice.
Result|
Result |
Proceed to |
|---|---|
|
System voice recognition level is low with any voice |
A |
|
System voice recognition level is low only for a particular voice |
B |
HINT:
| A | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| B | |
END |
Route cannot be Calculated
Cellular Phone Registration Failure, Phone Directory Transfer FailureOn-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FRONT AXLE HUB BEARING
(a) Remove the front wheel.
(b) for 4WD:
(1) Remove the front axle hub grease cap (See page
).
(c) Remove the front disc brake caliper (See page
).
(d) Remove the front disc.
(e) Inspect the axle hub backlash.
(1) Usi ...
Accelerator Pedal
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / En ...
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown.
If this happens, check and replace the fuses as necessary.
Turn the engine switch to the LOCK
position.
The fuses are located in the following
places. To check the fuses, follow the instructions below.
Engine comp ...