VEHICLE CONTROL HISTORY
VEHICLE CONTROL HISTORY
(a) A part of the control history can be confirmed using the vehicle control history.
Click here
Low Power Supply Voltage Malfunction (C1241)
DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU
(brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS
operation.
This DTC ...
Transfer L4 Position Switch Circuit (C1268)
DESCRIPTION
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1268
Transfer L4 Position Switch Circuit
Ei ...
Related Tacoma materials
Installation
INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT DETECTION ECU
(a) Check that the ignition switch is OFF.
(b) Check that the cable is disconnected from the battery negative (-) terminal
is disconnected.
CAUTION:
After removing the cable from the terminal, wait for at least 90 seconds before
star ...
Wheel Inspection and Replacement
If a wheel is bent, cracked, severely corroded, or otherwise structurally damaged, it should be replaced rather than repaired for continued use. A defective wheel can prevent the tire from remaining properly seated and may contribute to tire separation or a loss of vehicle control.
Wheel selection
W ...
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR SEAT CUSHION ASSEMBLY
(a) Remove the 6 bolts and 2 rear seat cushion assemblies.
2. REMOVE NO. 4 ROOM PARTITION COVER LH
3. REMOVE NO. 4 ROOM PARTITION COVER RH
4. REMOVE NO. 3 ROOM PARTITION COVER
...